當前位置: 選型首頁 >  HURST >  電機 >系列介紹

HURST  BAS   電機

收錄型號： 0條（帶參數型號： 0 條）

選型指南： 0 條 應用案例： 0 條

安裝調試： 0 條 安裝調試： 0 條

維護維修： 0 條 升級改造： 0 條

收藏

詳細介紹

Permanent Magnet DC Stepper BAS Direct Drive Specifications:

Step Angle:18?
Number of Phases:4 phase bifilar Standard
Lead Wire:6 leads 24AWG (approx. 12 inches [304.8 mm])
Operation Ambient Temp:-10?C to +40?C (approx.)
Note:  Typical data subject to change without notification

Additional Information:

This small stepping motor has a relatively high torque/inertia ratio. Its design recognizes the demand for small components to fit where space is severely limited.

The BAS series motor is available from stock in 5, 6, 12, and 24 volt models. They have a holding torque of 1.1 ounce-inch [7.8 mN-m]. All have a step angle of 18? or 20 steps per revolution.

Applications are found in a wide range of medical and scientific instruments and robotics. These stepping motors are also recommended for low duty - cycle, battery operated equipment.

BAS Direct Drive Drawings:

BAS Direct Drive Diagrams: